Dscp Settings - ZyXEL Communications GS1350 Series User Manual

IP Application > DiffServ
Fig ure 174
The following table describes the labels in this screen.
Table 109 IP Application > DiffServ
L ABEL
Active
Port
*
Active
Apply
Cancel
30.3 DSC P Se tting s
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 110 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
Chapter 30 Differentiated Services
DESC RIPT IO N
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select to enable Diffserv on the port.
Ac tive
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
0 – 7 8 – 15 16 – 23
0 1 2
GS1350 Series User's Guide
link on the top navigation panel to save
Sa ve
24 – 31 32 – 39 40 – 47
3 4 5
239
48 – 55 56 – 63
6 7