Zyxel One Network (Zon) Utility; Requirements - ZyXEL Communications GS1350 Series User Manual

Table 4 Web Configurator: Password/SNMP (continued)
L ABEL
Set Community
Trap Community
Apply
Cancel
4.3 Zyxe l O ne Ne two rk (ZO N) Utility
ZON Utility is a program designed to help you deploy and manage a network more efficiently. It detects
devices automatically and allows you to do basic settings on devices in the network without having to
be near it.
The ZON Utility issues requests via Zyxel Discovery Protocol (ZDP) and in response to the query, the device
responds back with basic information including IP address, firmware version, location, system and model
name in the same broadcast domain. The information is then displayed in the ZON Utility screen and you
can perform tasks like basic configuration of the devices and batch firmware upgrade in it. You can
download the ZON Utility at www.zyxel.com and install it on a PC.
4.3.1 Re q uire m e nts
Before installing the ZON Utility on your PC, please make sure it meets the requirements listed below.
O pe ra ting Syste m
At the time of writing, the ZON Utility is compatible with:
• Windows 7 (both 32-bit / 64-bit versions)
• Windows 8 (both 32-bit / 64-bit versions)
• Windows 8.1 (both 32-bit / 64-bit versions)
• Window 10 (both 32-bit / 64-bit versions)
Note: To check for your Windows operating system version, right-click on
Pro pe rtie s
Ha rdwa re
Here are the minimum hardware requirements to use the ZON Utility on your PC.
• Core i3 processor
• 2GB RAM
Chapter 4 Web Configurator
DESC RIPT IO N
Enter the
Se t C o m m unity
management station.
The string is only used by SNMP managers using SNMP version 2c or lower.
Se t C o m m unity
Enter the
T ra p C o m m unity
manager.
The string is only used by SNMP managers using SNMP version 2c or lower.
T ra p C o m m unity
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
. You should see this information in the
GS1350 Series User's Guide
string, which is the password for the incoming Set- requests from the
string, which is the password sent with each trap to the SNMP
Sa ve
G e ne ra l
47
link on the top navigation panel to
My C o m pute r
tab.
>