ZyXEL Communications GS1350 Series User Manual page 346

Click >
Switc hing L ink Ag g re g a tio n
Switching > Link Aggregation > Link Aggregation Setting
Fig ure 253
The following table describes the labels in this screen.
Table 173 Switching > Link Aggregation > Link Aggregation Setting
L ABEL DESC RIPT IO N
Link This is the only screen you need to configure to enable static link aggregation.
Aggregation
Setting
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Active Set this switch to on to activate a trunk group.
Criteria Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the
distribution type. If the Switch is behind a router, the packet's destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its IP address to make
sure port trunking can work properly.
Select
src - m a c
Select
dst- m a c
Select
src - dst- m a c
destination MAC addresses.
Select
src - ip
Select
dst- ip
Select
src - dst- ip
destination IP addresses.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port
security settings for a port, you cannot include the port in an active trunk group.
>
L ink Ag g re g a tio n Se tting
to distribute traffic based on the packet's source MAC address.
to distribute traffic based on the packet's destination MAC address.
to distribute traffic based on a combination of the packet's source and
to distribute traffic based on the packet's source IP address.
to distribute traffic based on the packet's destination IP address.
to distribute traffic based on a combination of the packet's source and
GS1350 Series User's Guide
346
to display the screen shown next.
src - dst- m a c