ZyXEL Communications GS1350 Series User Manual page 159

Advanced Application > Link Aggregation > Link Aggregation Setting
Fig ure 120
The following table describes the labels in this screen.
Table 69 Advanced Application > Link Aggregation > Link Aggregation Setting
L ABEL DESC RIPT IO N
Link This is the only screen you need to configure to enable static link aggregation.
Aggregation
Setting
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Active Select this option to activate a trunk group.
Criteria Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the
distribution type. If the Switch is behind a router, the packet's destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its IP address to make
sure port trunking can work properly.
Select
src - m a c
Select
dst- m a c
Select
src - dst- m a c
destination MAC addresses.
Select
src - ip
Select
dst- ip
Select
src - dst- ip
destination IP addresses.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port
security settings for a port, you cannot include the port in an active trunk group.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Chapter 17 Link Aggregation
to distribute traffic based on the packet's source MAC address.
to distribute traffic based on the packet's destination MAC address.
to distribute traffic based on a combination of the packet's source and
to distribute traffic based on the packet's source IP address.
to distribute traffic based on the packet's destination IP address.
to distribute traffic based on a combination of the packet's source and
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
GS1350 Series User's Guide
159
link on the top navigation panel to save
Sa ve
src - dst- m a c