ZyXEL Communications GS1350 Series User Manual page 149

Table 62 Advanced Application > Spanning Tree Protocol > RSTP (continued)
L ABEL DESC RIPT IO N
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to activate RSTP on this port.
Edge Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding
state immediately without going through listening and learning states right after the port is
configured as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge
Priority Configure the priority for each port here.
Priority decides which port should be disabled when more than one port forms a loop in a
switch. Ports with a higher priority numeric value are disabled first. The allowed range is
between 0 and 255 and the default value is 128.
Path Cost Path cost is the cost of transmitting a frame on to a LAN through that port. It is recommended
to assign this value according to the speed of the bridge. The slower the media, the higher the
cost - see
Apply Click
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
Protocol Data Unit (BPDU).
Table 59 on page 145
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
to begin configuring this screen afresh.
C a nc e l
GS1350 Series User's Guide
149
for more information.
link on the top navigation panel to
Sa ve