Activate The Automatic Pd Recovery - ZyXEL Communications GS1350 Series User Manual

Table 107 Advanced Application > Auto PD Recovery (continued)
L ABEL
Action
Resume Polling
Interval
PD Reboot Count
Resume Power
Interval
Apply
Cancel
28.2.1 Ac tiva te the Auto m a tic PD Re c o ve ry
Follow the steps below to activate the automatic PD recovery.
1
In the
Adva nc e d Applic a tio n
Fig ure 169
Chapter 28 Auto PD Recovery
DESC RIPT IO N
Set the action to take when the connected PD has stopped responding.
Select
Re b o o t- Ala rm
connecting port is detected as link-down) and turn it back ON again to restart the PD after
sending an SNMP trap and generating a log message.
When restarting, the PD entry disappears from the Switch's LLDP table and the
status LED will turn to yellow in the
details).
Select to have the Switch send an SNMP trap and generate a log message.
Ala rm
Specify the number of seconds the Switch waits before monitoring the PD status again after it
restarts the PD on the port.
Specify how many times the Switch attempts to restart the PD on the port.
The
PD Re b o o t C o unt
• as soon as a ping is successful,
• or when any modification to the
• or after restarting the Switch.
Specify the number of seconds the Switch waits before supplying power to the connected PD
again after it restarts the PD on the port.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
>
Auto PD Re c o ve ry
Auto PD Recovery (Ping Mode)
GS1350 Series User's Guide
to have the Switch turn OFF the power of the connected PD (the
>
Sta tus Ne ig hb o r
will reset
Auto PD Re c o ve ry
screen, activate the feature.
232
screen (see Section 7.2.1 on page 84
screen is applied,
link on the top navigation panel to
Sa ve
PD He a lth
for