ZyXEL Communications GS1350 Series User Manual page 263

Management > Maintenance > Tech-Support
Fig ure 196
You may need WordPad or similar software to see the log report correctly. The table below describes
the fields in the above screen.
Table 126 Management > Maintenance > Tech-Support
L ABEL DESC RIPT IO N
CPU Type a number ranging from 50 to 100 in the CPU threshold box, and type another
number ranging from 5 to 60 in the seconds box then click
For example, 80 for CPU threshold and 5 for seconds means a log will be created when
CPU utilization reaches over 80% and lasts for 5 seconds.
The log report holds 7 days of CPU log data and is stored in volatile memory (RAM). The
data is lost if the Switch is turned off or in event of power outage. After 7 days, the logs
wrap around and new ones and replace the earliest ones.
The higher the CPU threshold number, the fewer logs will be created, and the less data
technical support will have to analyze and vice versa.
Mbuf Type a number ranging from 50 to 100 in the Mbuf (Memory Buffer) threshold box. The
Mbuf log report is stored in flash (permanent) memory.
For example, Mbuf 50 means a log will be created when the Mbuf utilization is over 50%.
The higher the Mbuf threshold number, the fewer logs will be created, and the less data
technical support will have to analyze and vice versa.
Apply Click
these changes if it is turned off or loses power, so use the
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click
All Click
memory. If the
below.
Crash Click
crash and is stored in flash memory.
CPU history Click
will need to save it, otherwise it will be lost when the Switch is shutdown or during power
outage.
Memory Section Click
memory.
Chapter 33 Maintenance
to save your changes to the Switch's run-time memory. The Switch loses
Apply
to begin configuring this screen afresh.
C a nc e l
to see all the log report and system status. This log report is stored in flash
Do wnlo a d
log report is too large, you can download the log reports separately
All
to see the crash log report. The log will include information of the last
Do wnlo a d
to see the CPU history log report. The 7-days log is stored in RAM and you
Do wnlo a d
to see the memory section log report. This log report is stored in flash
Do wnlo a d
GS1350 Series User's Guide
263
.
Apply
link on the top navigation
Sa ve