Restore Button; Restore Custom Default; Reboot The Switch; Rear Panel - ZyXEL Communications GS1350 Series User Manual

Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5
Insert the dust plug into the ports on the transceiver and the cables.
Removing the Fiber Cables
Fig ure 17
Opening the Transceiver's Latch Example
Fig ure 18
Transceiver Removal Example
Fig ure 19
3.1.4 Dua l Pe rso na lity Inte rfa c e s
A combo port is for uplink connections. It consists of a Gigabit Ethernet port for Ethernet connection,
and a SFP transceiver slot for fiber connection. The fiber connection takes priority if the corresponding
Gigabit port is also connected.
• 100 Mbps/1 Gbps – Connect these ports to high-bandwidth backbone network Ethernet switches.
• Transceiver Slots – Use SFP transceivers in these slots for connections to backbone Ethernet switches.
Combo Port Example: Gigabit Port and SFP Transceiver Slot
Fig ure 20
3.2 Re a r Pa ne l
The following figures show the rear panels of the Switch.
Chapter 3 Hardware Panels
GS1350 Series User's Guide
36