ZyXEL Communications GS1350 Series User Manual page 129

You can set priority level to the Voice VLAN and add MAC address of IP phones from specific
manufacturers by using its ID from the Organizationally Unique Identifiers (OUI).
Click the
Vo ic e VL AN Se tup
shown.
Advanced Application > VLAN > VLAN Configuration > Voice VLAN Setup
Fig ure 103
The following table describes the fields in the above screen.
Table 52 Advanced Application > VLAN > VLAN Configuration > Voice VLAN Setup
L ABEL DESC RIPT IO N
Voice VLAN Global Setup
Voice VLAN Click the second radio button if you want to enable the Voice VLAN feature. Enter a
VLAN ID number that is associated with the Voice VLAN.
Click the
Priority Select the priority level of the voice traffic from 0 to 7. Default setting is 5. The higher the
numeric value you assign, the higher the priority for this voice traffic.
Apply Click
changes if it is turned off or loses power, so use the
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click
Clear Click
Voice VLAN OUI Setup
OUI address Type the IP Phone manufacturer's OUI MAC address. The first 3 byes is the manufacturer
identifier, the last 3 bytes is a unique station ID.
OUI mask Type the mask for the specified IP Phone manufacturer's OUI MAC address to determine
which bits a packet's MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should
match. Enter "0" for the bits of the matched traffic's MAC address, which can be of any
hexadecimal characters. For example, if you set the MAC address to 00:13:49:00:00:00
and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56
matches this criteria.
Chapter 9 VLAN
link in the
VL AN C o nfig ura tio n
radio button if you do not want to enable the Voice VLAN feature.
Disa b le
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
to begin configuring this section afresh.
C a nc e l
to reset the fields to default settings.
C le a r
GS1350 Series User's Guide
129
screen to display the configuration screen as
link on the top navigation panel
Sa ve