ZyXEL Communications GS1350 Series User Manual page 87

Table 23 Status > Neighbor > Neighbor Detail (continued)
L ABEL DESC RIPT IO N
PD Health This shows the status of auto PD recovery on this port.
•
•
•
•
Link This shows the speed (either
the duplex (
connected to any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the Switch.
PWR Cycle Click the
again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Remote
System Name This shows the system name of the neighbor device.
Model This shows the model name of the neighbor device. This field will show "
do not support the ZON utility.
Firmware This shows the firmware version of the neighbor device. This field will show "
that do not support the ZON utility.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a
you can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a
you can click to log into and manage the neighbor device through its Web Configurator.
Port This show the number of the neighbor device's port which is connected to the Switch.
Desc. This shows the description of the neighbor device's port which is connected to the
Switch.
Location This shows the geographic location of the neighbor device. This field will show "
devices that do not support the ZON utility.
MAC This shows the MAC address of the neighbor device.
Reset to Default Click the
warning message "
you to confirm the action. After confirming the action a count down button (from 5 to 0)
starts.
Note:
•
•
•
Chapter 7 Status
Red: The Switch failed to get information from the PD connected to the port using
LLDP, or the connected PD did not respond to the Switch's ping requests.
Yellow: The Switch is restarting the connected PD by turning the power off and
turning it on again.
Green: The Switch successfully discovered the connected PD using LLDP or ping.
: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does
–
not supply power to the connected PD.
10M
for full duplex or
F H
button to turn OFF the power of the neighbor device and turn it back ON
C yc le
powered device (PD).
button to reset the neighbor device to its factory default settings. A
Re se t
Are yo u sure yo u wa nt to lo a d fa c to ry de fa ult?
The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
If multiple neighbor devices use the same port, the
You can only reset Zyxel powered devices that support the ZON utility.
GS1350 Series User's Guide
87
for 10Mbps, for 100Mbps, or
100M
for half). This field displays
Do wn
Re se t
for 1 Gbps) and
1G
if the port is not
" for devices that
–
" for devices
–
that
hype r link
that
hype r link
" for
–
" appears prompting
button is not available.