Basic Setting; C Ha Pte R 8 Ba Sic Se Tting; Overview; What You Can Do - ZyXEL Communications GS1350 Series User Manual

8.1 O ve rvie w
This chapter describes how to configure the
,
Se tup Po E Se tup
8.1.1 Wha t Yo u C a n Do
• Use the
Syste m Info
monitor the Switch temperature.
• Use the
G e ne ra l Se tup
system name and time.
• Use the
Switc h Se tup
to queues.
• Use the
IP Se tup
device, management VLAN ID, and proxy server.
• Use the
Po rt Se tup
• Use the
Po E Se tup
are receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the
Inte rfa c e Se tup
interface ID settings.
• Use the
IPv6
• Use the
C lo ud Ma na g e m e nt
C e nte r Disc o ve ry
8.2 Syste m Info rm a tio n
In the navigation panel, click
to view general system information. You can check the firmware version number and monitor the Switch
temperature.
Chapter 8 Basic Setting
, , , and
Inte rfa c e Se tup IPv6
screen (Section 8.2 on page
screen (Section 8.3 on page
screen (Section 8.5 on page
screen (Section 8.6 on page
screen (Section 8.7 on page
screens (Section 8.8 on page
screens (Section 8.9 on page
screens (Section 8.10 on page
screen (Section 8.11 on page
and
Ne b ula Switc h Re g istra tio n
Ba sic Se tting
GS1350 Series User's Guide
C
Ba sic Se tting
,
Syste m Info G e ne ra l Se tup
screens.
C lo ud Ma na g e m e nt
88) to check the firmware version number and
90) to configure general settings such as the
92) to choose your VLAN type and assign priorities
94) to configure the Switch IP address, default gateway
99) to configure Switch port settings.
101) to view the current amount of power that PDs
107) to configure Switch interface type and
108) to view IPv6 status and IPv6 configuration.
119) to display links to
screens.
> to display the screen as shown. Use this screen
Syste m Info
88
HA PTER
, ,
Switc h Se tup IP Se tup
Ne b ula C o ntro l
8
,
Po rt