Uploading Firmware File Via Console Port; Example Xmodem Firmware Upload Using Hyperterminal; Figure 31-16 Menu 24.7.1 As Seen Using The Console Port; Figure 31-17 Example Xmodem Upload - ZyXEL Communications Prestige 792H User Manual

Prestige 792H User's Guide

31.4.8 Uploading Firmware File Via Console Port

Step 1. Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.1
– System Maintenance – Upload System Firmware, then follow the instructions as shown in
the following screen.

Figure 31-16 Menu 24.7.1 as seen using the Console Port

Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.

31.4.9 Example Xmodem Firmware Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.
After the configuration upload process has completed, restart the Prestige by entering "atgo".
31-14
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
Prestige.
Warning: Proceeding with the upload will erase the current system
firmware.
Do You Wish To Proceed:(Y/N)

Figure 31-17 Example Xmodem Upload

Type the firmware file's location, or
click Browse to look for it.
Choose the Xmodem protocol.
Then click Send.
Firmware and Configuration File Maintenance