10.3 Restore Configuration
Menu 24.6 -- System Maintenance - Restore Configuration allows you to restore the configuration via
the console port.
FTP and TFTP are the preferred methods for restoring your current workstation configuration to your
ZyWALL since FTP and TFTP are faster. Please note that the system reboots automatically after the file
transfer is complete.
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Figure 10-2 Menu 24.6 - System Maintenance - Restore Configuration
10.4 Upload Firmware
Menu 24.7 -- System Maintenance - Upload Firmware allows you to upgrade the firmware and the
configuration file via the console port. There are two components in the system: the router firmware and the
configuration file, as shown below.
Figure 10-3 Menu 24.7 - System Maintenance - Upload Firmware
10.4.1 Uploading the Router Firmware
Menu 24.7.1 shows you the instructions for uploading the router firmware. Follow the procedure below to
upload the file:
Step 1.
Enter y at the prompt to go into debug mode.
Step 2.
Enter atur after Enter Debug Mode message.
Step 3.
Wait for the Starting XMODEM upload message before activating Xmodem upload on
your terminal.
Transferring Files
Menu 24.6 -- System Maintenance - Restore Configuration
Menu 24.7 -- System Maintenance - Upload Firmware
1. Upload Router Firmware
2. Upload Router Configuration File
Enter Menu Selection Number:
ZyWALL 10 Internet Security Gateway
10-3