Ricoh M281 Series Service Manual page 858

Error Codes
Code
No post-message response
0-07 from the other party after a
page was sent
The other party sent RTN or
PIN after receiving a page,
0-08
because there were too many
errors
Non-standard post message
0-14
response code received
D255/D256 FAX OPTION
Meaning












Reference:







Reference:
See error code 0-08.
Suggested Cause/Action
Check the connection.
Replace the FCU.
The other party is out of paper or has a
paper jam.
The other party may have disconnected
the call.
Check for a bad line.
The other machine may be defective. Try
sending to another machine.
Check the connection.
Replace the FCU.
The other party may have a paper jam, or
run out of paper or memory space.
Try adjusting the TX level and/or cable
equalizer settings.
The other party may have a defective
modem/FCU; try sending to another
machine.
Check for line problems and noise.
TX level: NCU Parameter 01 (PSTN)
Cable equalizer: G3 Switch 07 (PSTN)
Dedicated TX parameters in Service
Program Mode
Incompatible or defective remote terminal;
try sending to another machine.
Noisy line; resend.
Try adjusting the TX level and/or cable
equalizer settings.
Replace the FCU.
24 SM