shown below.
19. Connect the connector of the speaker.
20. Connect the flat cable [A] to CN603 of the removed FCU board [B].
21. Turn ON the main power.
SRAM data transmission starts. When the transmission is completed, you will hear a beeper
sound.
The beeper sound is at the same volume as the speaker sound.
The beeper sounds even if the speaker sound is turned off.
If the beeper does not sound, repeat the main power OFF/ON until the beeper
sounds, and then perform the transmission procedure. If the data cannot be
transmitted, repeat transmission 2 or 3 times.
If the beeper does not sound after turning the main power OFF/ON 3 times, you need
SM
17
FCU
D255/D256 FAX OPTION