Ricoh M281 Series Service Manual page 795

1001 Bit Switch
bit 0 PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
To be used if PDL auto-detection fails. A failure of PDL autodetection does
not necessarily mean that the job can't be printed. This bit switch tells the
device whether to time-out immediately (default) upon failure or to wait 10
seconds.
bit 1 Not used
bit 2 Job Cancel
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this BitSwitch is enabled, printing under the following conditions
might result in problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
bit 3 Not used
bit 4 Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
This BitSwitch determines the timing of the PJL USTATUS JOB END sent
when multiple collated copies are being printed.

0 (default): JOB END is sent by the device to the client after the first copy
has completed printing. This causes the page counter to be incremented
after the first copy and then again at the end of the job.

1: JOB END is sent by the device to the client after the last copy has
finished printing. This causes the page counter to be incremented at the
end of each job.
bit 5 Display UTF-8 text in the operation panel
SM Appendix
Disabled
(Immediately)
Disabled (Not
cancelld)
Disabled
Enabled
3-155
Printer Service Mode
Enabled
(10 seconds)
- -
Enabled
(Cancelled)
- -
Enabled
Disabled
D255/D256/M281/M282