Ricoh M281 Series Service Manual page 912

Bit Switches - 1
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
5-7 Not used
* This setting can be used for the client machine which has no FCU.
No Function
0 Not used
1 Report printout after an original
jam during SAF storage or if the
SAF memory fills up
0: Enabled
1: Disabled
2 Not used
3 Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
4-6 Not used
D255/D256 FAX OPTION
0: If the user has stored no acceptable sender
RTIs or CSIs, the user can select "ON" in the
authorized reception setting but the setting
becomes invalid ("OFF"). The machine will not
be able to receive any fax messages.
If the customer wishes to receive messages
from any sender that includes an RTI or CSI,
and to block messages from senders that do
not include an RTI or CSI, change this bit to
"0", then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
Do not change the settings
System Switch 1F (SP No. 1-101-032)
Do not change the settings.
0: When an original jams, or the SAF memory
overflows during scanning, a report will be
printed.
Change this bit to "1" if the customer does not
want to have a report in these cases.
Memory TX – Memory storage report
Parallel memory TX – Transmission result
report
Do not change the settings.
0: The machine prints each page immediately
after the machine receives it.
1: The machine prints the complete message
after the machine receives all the pages in the
memory.
Do not change the factory settings.
Comments
78 SM