Ricoh M281 Series Service Manual page 903

3 Printing dedicated TX
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
No Function
0 Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
1 Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS
communication (default),
1: After polling
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the
error report
0: No 1: Yes
SM
1: Each Quick/Speed dial number on the list is
printed with the dedicated TX parameters (10
bytes each).
The first 10 bytes of data are the programmed
dedicated TX parameters; 34 bytes of data are
printed (the other 24 bytes have no use for
service technicians).
Do not change these settings.
System Switch 09 (SP No. 1-101-010)
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
0: The Journal is printed only when image data
is sent.
1: The Journal is printed when any data is sent.
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which
occurs rarely.
69
Bit Switches - 1
Comments
D255/D256 FAX OPTION