Ricoh M281 Series Service Manual page 818

Scanner Features (MP 501/601 Only)
4.2 SCANNER FEATURES (MP 501/601 ONLY)
4.2.1 DISPLAY SETTINGS OF RECENTLY USED SCAN
DESTINATION
Configuring the scanner interface so that the most recently used scan destination is cleared.
Whether the MFP clears the most recently used scan destination, can be configured using
Scanner SP 1-012-001.
By default, this is cleared to avoid subsequent users scanning to it by mistake.
Scanner SP 1-012-001
1 (default): Clear
0: Do not clear
This will cause all of the following to be cleared after the scanning is complete:

Destination

Sender

Email subject

Email message

File name
Scanner SP 1-012-001=1 (default):
Exceptions:

User Auth.:
If SP 1-012-001 = 0 and if User Auth. (excluding User Code authentication) is enabled, the
most recently used scan destination will only be retained until the user logs out.

Scanner Auto Reset timer:
Even if SP 1-012-001 = 0 the most recently used scan destination can still be cleared by the
Scanner Auto Reset timer. If the Scanner Auto Reset timer is shorter than the System Auto
Reset timer, then the most recently used scan destination will be cleared when the Scanner
Auto Reset timer elapses.
D255/D256/M281/M282 4-10 SM Appendix