Configuring The Data Port Interface; Communication Protocol - Nellcor OXIMAX N-600X Series Service Manual

Managing the Data Port
2. Verify the communications format is compatible with the data port of the
oximeter. If the communications format is compatible, real-time data begins to be
displayed on the computer.
3. Capture the text to a file.
4. Press Ctrl-C to halt the data flow.
5. Import the data file into the spreadsheet. The data can now be manipulated by
the commands of the spreadsheet. Some formatting of the data may be
necessary.

Configuring the Data Port Interface

Obtain printouts or patient data by connecting an appropriate RS-232 cable to the
data port on the back of the OxiMax N-600x pulse oximeter and communicating with
a Nellcor Oxinet™ III monitoring system or personal computer. The data port also
provides analog signals representing SpO
as providing a remote nurse call function.
The OxiMax N-600x pulse oximeter provides a bedside oximeter communication for
interfacing with Philips monitors.
Adjust data port options using the appropriate softkey menu items.

Communication Protocol

Overview
WARNING
Do not silence or decrease the volume of the OxiMax N-600x pulse oximeter audible
alarm if patient safety could be compromised.
Note:
Setting the communication protocol automatically sets the communication baud rate.
Change the baud rate to match the abilities of any attached equipment. Perform the
following procedure to change the baud rate.
To adjust the communication baud rate:
1. Turn on the oximeter by pressing the ON/STANDBY button.
2. Press the SETUP softkey.
3. Press the NEXT softkey twice.
4. Press the COMM softkey.
5. Use the ADJUST UP and ADJUST DOWN buttons to select the desired baud rate.
6. Press the EXIT softkey to set the baud rate. The baud rate setting will be in effect
until the oximeter is powered off.
84
, pulse rate, and pulse amplitude, as well
2
10030881 Rev. B 12-2008
Service Manual