Repairing the Oximeter
7. Separate the oximeter's top and bottom cases without stressing the connection
harnesses between the cases.
Caution
To avoid stress or damage to the power supply wiring harness, ensure the top enclosure is
lying flat on the work surface.
8. Place the two halves of the oximeter on the static-free work surface.
9. Disconnect the oximeter's power supply harness from J200 (3) located on the
Main Board printed circuit board (PCB).
168
Figure 126. Opening the Oximeter Casing
3
2
1
Table 36. Opening Oximeter Casting Figure Callouts
No
1
J4 Connector
2
J7 Connector
3
J200 Connector
4
J10 Connector
5
J9 Connector
6
J3 Connector
7
J2 Connector
10030881 Rev. B 12-2008
4
5
6
7
POX_10046_A
Description
Service Manual