Managing The View Display; Adjusting The Volume Of Audible Tones; Adjusting The Pulse Beep Volume; Managing Oximeter Alarms - Nellcor OXIMAX N-600X Series Service Manual

Operating the Oximeter
2. Press the ADJUST UP or ADJUST DOWNkey below the
oximeter panel until the desired backlight brightness is obtained.
To adjust the oximeter screen contrast
1. With the oximeter in the normal monitoring mode, press and hold the HELP/
CONTRAST softkey while pressing the ADJUST UP or ADJUST DOWN key below
the
ALARM SILENCE
2. Press the HELP/CONTRAST key to return to the normal monitoring mode.

Managing the View Display

Select the preferred method of viewing real-time data. Reference Oximeter Display
View Options, page 26, for details. Selections will last until power-cycling the
oximeter or manually selecting another view.

Adjusting the Volume of Audible Tones

Adjusting the Pulse Beep Volume

The pulse beep emits its tone with each real-time event, based on data received from
the sensor.
To adjust the pulse beep volume
1. With the oximeter in the normal monitoring mode, press and hold the ADJUST UP
key below the
beep volume.
2. With the oximeter in the normal monitoring mode, press and hold the ADJUST
DOWN key to decrease the pulse beep volume.

Managing Oximeter Alarms

Alarms occur when the oximeter detects a condition that requires user intervention
or attention. The Alarm Volume allows for volume adjustment of alarm tones.
To set the alarm volume
1. With the oximeter in the normal monitoring mode, press the ALARM SILENCE key
until the alarm volume level displays and sounds on the oximeter.
62
key on the oximeter panel until obtaining the desired contrast.
key on the oximeter panel to increase the pulse
ALARM SILENCE
Figure 22. Alarm Volume Control Screen
10030881 Rev. B 12-2008
key on the
ALARM SILENCE
Service Manual