Interface/Powerbase Rear Panel - Nellcor N-200 Operator's Manual

Setup

Interface/Powerbase Rear Panel

NELLCOR INCORPORATED
INTERFACE/POWERBASE
SERIAL NO.
100-120 Vac
REPLACE FUSE AS MARKED
MADE IN USA NELLCOR INC, PLEASANTON, CA 94588
33
16. ZERO button: Provides a zero-volt signal on PULSE,
SAT, and RATE analog outputs.
17. FULL button: Provides a full-scale signal on PULSE,
SAT, and RATE analog outputs. (The voltage depends on
VOLT switch setting).
18. SpO
oxygen saturation at 0–100% or 50%–100%.
19. VOLT switch: Sets the voltage output range for the
analog outputs.
20. TREND button: Initiates a trend memory output sequence.
21. EVENT button: Initiates an event memory output
sequence.
22. ECG IN/OUT connector: Provides an analog ECG output
signal or can be used for an input from an external ECG
monitor.
18
ELETRICAL RATING
SLOW BLOW
.3A 50/60 Hz
FUSE ONLY
WARNING
Figure 3: Interface/Powerbase Rear Panel
% SCALE switch: Sets the analog output scale for
2
16
ZERO
USE .5A
PULSE
DATA
32 31 30 29
17 18 19 20 21
FULL TREND EVENT
S O %
a 2
SCALE VOLT
SAT RATE ECG
0- 0-1
100
50-
1 2
100 0-10 IN/OUT
1
SERIAL COMM
2
3
4
5
6
1 2 3 4 5 6 7 8
7
8
REFER TO MANUAL
28 27 26
1 2 3 4 5 6 7 8
25 24
22
ADULT/
NEONATAL
ALARM
RS232
FORMAT
BAUD
RATE
23