Nellcor OXIMAX N-600X Series Service Manual page 149

Error Code
560
561
562
%SpO
563
564
565
566
567
568
569
570
574
575
576
577
578
579
580
581
582
583
650
651
Service Manual
Table 26. Error Code Listing for Non-correctable Failures
Category
Memory corruption detected.
RTOS Resource unavailable.
%SpO front end reset.
2
front end
2
%SpO reported error.
2
Clinical mode was exited after input was received.
Comm Communication failures between software modules.
Excessive resets before UIF runs.
UIF An unexpected interrupt has been asserted.
General failure in UIF module generic post.
BOOT application program is corrupt - CRC does not match.
RTC was restarted.
Excessive restarts within one minute.
Trend data Trend data corrupted
Logic Processing Board (LPS) is going through excessive resets.
LPS status messages not arriving in a timely manner.
LPS driver has received too many corrupt (protocol error) messages.
LPS
Status report AC OK bit does not equal the hardware AC OK signal.
LPS driver received only a partial LPS message.
Too many corrupt (invalid data) message.
Unable to enter shelf-mode, this could mean that the LPS is dead or there
is a serial port transmit problem.
Speaker Primary speaker failure detected.
Oximetry module reports internal software consistency check failed.
Module
Oximetry module reports software functions executed before
initialization completed.
10030881 Rev. B 12-2008
Prompts, Error Messages, and Error Codes
Description
149