Error Codes - Nellcor OXIMAX N-600X Series Service Manual

Troubleshooting
Message
READING
TRENDS...
REPLACE
SENSOR
RESET
DEFAULTS?
SAVE
DEFAULTS?
SENSOR
DISCONNECTED
SENSOR TYPE

Error Codes

When the OxiMax N-600x pulse oximeter detects an error condition, it displays "EEE"
followed by an error code of up to three digits.
144
Table 24. Common Prompts and Error Messages
Time- Exit on
out in Exit on Alarm
secs Alarm? Silence?
None Yes Yes
None No Yes
10 No Yes
10 No Yes
None No Yes
5 No No
Figure 120. Error Condition Screen, Battery Failure
10030881 Rev. B 12-2008
Displayed
When the oximeter Completely retrieve sensor
needs more than data or select ABORT.
four to six seconds to
retrieve trend data
from memory.
When the sensor or Temporarily acknowledge by
cable wiring is pressing the ALARM SILENCE
defective. key. Replace sensor.
When attempting to Leave default settings as they
reset oximeter to are by selecting NO, or revert
factory default back to the original factory
setting by pressing default settings by selecting
the RESET softkey on YES.
the PARAMS menu.
When attempting to Confirm the new institutional
save current settings default settings by selecting
as power-on defaults YES, or leave default settings
by pressing SAVE in as they are by selecting NO,
the PARAMS menu.
When the sensor is Temporarily acknowledge by
disconnected from pressing the ALARM SILENCE
the pulse oximetry key. Connect the cable and
cable, the cable is not sensor to the oximeter,
connected to the reconnect the sensor, or
oximeter, or the cable check all connections. If this
wiring is defective. does not clear the condition,
replace the cable and/or
sensor.
First message Automatically clears on
displayed when a time-out.
sensor is connected
to the oximeter.
Resolution
Service Manual