Nellcor OXIMAX N-600X Series Service Manual page 70

Operating the Oximeter
To change the displayed language setting
1. With the oximeter in the normal monitoring mode, press the SETUP softkey.
2. Press the NEXT softkey.
3. Press the LANG softkey.
4. Use the ADJUST UP or ADJUST DOWN keys below the ALARM SILENCE key on the oximeter
5. Press the EXIT softkey.
Note:
The selected language displays until the oximeter is turned OFF. Any changes in language selection do
not last beyond power-off, but return to default English, unless qualified service personnel set the
selected language as a default by following the procedures outlined in Service Function Menus, page 130.
1. COMM Menu—From the SETUP menu, press the NEXT softkey. Use the SELECT
softkey to toggle between the baud rate and communication protocol. Arrow up
or down to select the proper baud rate. Baud rates include 19200, 9600, and 2400
baud for all protocols except SPDout, which allows 115200, 57600, and 19200
baud. Arrow up or down to select the proper communication protocol. The
OxiMax N-600x pulse oximeter provides a bedside monitor communication for
interfacing with the protocols listed below. The factory default protocol is ASCII.
70
To Purchase, Visit Avobus.com
Figure 28. Displayed Language Selection Screen
panel to select the desired language.
Table 13. Communication Protocol Options
Communication
Protocols
ASCII
CLINICAL
GRAPH (Graphics)
OXINET
PHILIPS
SPACELBS (Spacelabs)
MARQ (GE Marquette)
DATEX (Datex-Ohmeda)
SPDout
10030881 Rev. B 12-2008
or call 1-800-674-3655
N-600x using up to N-600x with Firmware 2.0
Firmware 2.0
Default Baud Rate Default Baud Rate
9600
19200
9600
9600
19200
9600
9600
2400
N/A Default
and above
9600
19200
N/A
N/A
19200
Use only 19200
N/A
N/A
N/A
115200
Available:
19200, 57600, 115200
Service Manual