Xerox WorkCentre 5687 Series Service Manual page 1543

REP 11.60-171 BM Paper Guide Assembly
Parts List on PL 11.161
Purpose
This procedure is used to repair the following components:
• Paper guide, PL 11.161 Item 7.
• Nip spring, PL 11.161 Item 9.
• Nip roll, PL 11.161 Item 10.
• Nip shaft, PL 11.161 Item 11.
NOTE: If only new nip components are being installed, the BM paper guide assembly
does not need to be removed.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the BM front door and fully pull out the BM.
2. Rotate the crease roll handle (6c) fully counterclockwise.
3. Remove the crease blade knob (6d), PL 11.161 Item 4.
4. Remove the crease roll handle (6c), PL 11.161 Item 4.
5. Remove the BM front cover, PL 11.161 Item 3.
WorkCentre 5687 Family
6. Figure 1, remove the front bearing.
2
Remove the bearing
Figure 1 Front bearing removal
August 2007
4-523
1
Remove
the E-clip
Repairs/Adjustments
REP 11.60-171