Xerox WorkCentre 5687 Series Service Manual page 1490

REP 11.24-171 BM Crease Roll Gate Motor
Parts List on PL 11.166
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the top cover, then the rear cover, REP 11.1-171.
2. Fully pull out the BM module.
3. Figure 1, remove the motor assembly
Figure 1 Motor assembly removal
4. Remove 3 nuts to release the motor from the bracket.
Replacement
Reverse the removal procedure to replace the BM crease roll gate motor.
Repairs/Adjustments
REP 11.24-171, REP 11.25-171
1
Remove E-clip
and pulley
2
Remove 2
screws
3
Disconnect the
motor harness
4
Remove the
motor assembly
August 2007
REP 11.25-171 BM Compiler Motor and BM Flapper Motor
Parts List on PL 11.166
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the top cover, then the rear cover, REP 11.1-171.
2. Fully pull out the BM module.
3. Figure 1, remove the motor assembly.
Figure 1 Motor assembly removal
4. Remove 2 screws to remove the relevant motor from the bracket.
5. Remove 2 screws to remove the motor from the damper.
Replacement
Reverse the removal procedure to replace the BM compiler motor or BM flapper motor.
4-470
WARNING
WARNING
4
Remove the
motor assembly
3
Remove 3 screws
2
Disconnect the
ground strap
1
Disconnect the
harness
WorkCentre 5687 Family