Xerox WorkCentre 5687 Series Service Manual page 1521

REP 11.46-171 HVF Stacker Exit Feed Roll
Parts List on PL 11.155
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Figure 1. Remove the circlip and bush
Figure 1 Circlip and bush removal.
WorkCentre 5687 Family
6. Figure 2. Remove the stacker exit feed roll.
Replacement
The replacement procedure is the reverse of the removal procedure.
Remove the circlip
and the bush
August 2007
4-501
1
Remove the idler,
(1 screw)
2
Remove the circlip,
pulley and bush
3
Remove the stacker
exit feed roll
REAR VIEW
Figure 2 Stacker exit feed roll removal.
Repairs/Adjustments
REP 11.46-171