Xerox WorkCentre 5687 Series Service Manual page 1517

REP 11.42-171 HVF Buffer Pocket Roll
Parts List on PL 11.155
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Remove the punch unit, or the punch unit guide, as appropriate.
6. Figure 1. At the front of the HVF, remove the circlip and bush.
Figure 1 Circlip and bush removal.
WorkCentre 5687 Family
7.
Replacement
The replacement procedure is the reverse of the removal procedure.
Remove the circlip
and the bush
August 2007
4-497
At the rear of the HVF, remove the buffer pocket roll. The bracket can be moved if neces-
sary, to improve access, (two screws), Figure 2.
Bracket
REAR VIEW
Figure 2 Buffer pocket roll removal.
1
Remove the circlip
2
Slide the pulley and the
bush along the shaft
3
Slip the belt off the
pulley
4
Remove the pulley and
the bush
5
Remove the buffer
pocket roll
Repairs/Adjustments
REP 11.42-171