Xerox WorkCentre 5687 Series Service Manual page 1446

REP 11.60-170 BM Paper Guide Assembly
Parts List on PL 11.80
Purpose
This procedure is used to repair the following components:
• Paper guide, PL 11.80 Item 7.
• Nip spring, PL 11.80 Item 9.
• Nip roll, PL 11.80 Item 10.
• Nip shaft, PL 11.80 Item 11.
NOTE: If only new nip components are being installed, do not remove the BM paper
guide assembly.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the BM front door and fully pull out the BM.
2. Rotate the crease roll handle (6c) fully counterclockwise.
3. Remove the crease blade knob (6d), PL 11.80 Item 4.
4. Remove the crease roll handle (6c), PL 11.80 Item 5.
5. Remove the BM front cover, PL 11.80 Item 3.
6. Figure 1, remove the front bearing.
Repairs/Adjustments
REP 11.60-170
2
Remove the bearing
Figure 1 Front bearing removal
7. Figure 2, remove the rear bearing.
August 2007
4-426
1
Remove
the E-clip
WorkCentre 5687 Family