Xerox WorkCentre 5687 Series Service Manual page 1430

Figure 7 Outermost gear keyed clutch plate
d. Figure 8, ensure that the final shaft keyed clutch plate does not come off of the shaft
during installation.
Figure 8 Outermost gear keyed clutch plate
e. Tighten the screw on the front end of the shaft until it reaches a hard stop.
f. Check that the lower crease roll gear and clutch assembly is secure on the shaft. If
necessary, repeat steps A to D.
Repairs/Adjustments
REP 11.52-170
3. Install the remainder of the removed components by reversing the removal procedure.
Outermost gear
keyed clutch plate
Tabs
Grooves
Final shaft keyed
clutch plate
August 2007
4-410 WorkCentre 5687 Family