Xerox WorkCentre 5687 Series Service Manual page 1575

REP 11.93-171 Pickup and Paper Path Sensors
Parts List on PL 11.177
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the PPI front and rear covers, REP 11.83-171
2. Remove the inserter motor, REP 11.84-171.
3. Remove the pickup roll assembly, REP 11.95-171.
4. Remove the top cover, REP 11.91-171.
5. Remove the top inside cover, Figure 1.
Top Inside Cover
Figure 1 PPI Top and Inside Cover
WorkCentre 5687 Family
6.
Replacement
Reverse the removal procedure to replace the pickup and paper path sensors.
When replacing the top inside cover, and the top cover make sure that the correct screws are
used and that the screws are not overtightened GP 6
Top Cover
Pivot Screw
Top Cover
August 2007
4-555
Release the wiring harness clips to give slack in the sensor connecting cables. Remove
the sensor assembly bracket then disconnect the PJs and unclip the sensors from the
bracket, Figure 2.
Pickup and Paper Path Sensor Bracket
Sensors
Figure 2 Pickup and Paper Path Sensors
Idle Roll Assembly
Harness Clips
Repairs/Adjustments
REP 11.93-171