Xerox WorkCentre 5687 Series Service Manual page 1691

ADJ 11.3-171 Stapler Anvil Alignment
Parts List on PL 11.168
Purpose
To ensure the correct alignment of the stapler anvil to the stapler throat.
Special Tools Required
Stapler alignment tool, supplied with the HVF BM, located on the left of the BM frame.
NOTE: This procedure illustrates the front stapler. The procedure for adjusting the rear stapler
is identical.
Adjustment
WARNING
Switch off the electricity to the machine GP 14. disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. To improve the access to the two clamp screws for the anvil, remove the tamper assem-
bly, REP 11.30-171.
2. Fully pull out the BM module. Remove the stapler cover(s), one screw on each. Pull the
stapler bracket handle and swing open the stapler bracket.
3. Figure 1, insert the alignment tool.
WorkCentre 5687 Family
2
Press the tool firmly into
place and slowly close
the stapler bracket
Figure 1 Alignment tool insertion
4. Figure 2, loosen the anvil.
August 2007
4-671
1
Insert the stapler
alignment tool into
the stapler throat
Repairs/Adjustments
ADJ 11.3-171