10. Remove the tape from the capstan and from the fly-wheel weights. Ensure all tape is
removed from the area.
11. Repeat steps 2 to 10 for the inboard cable.
12. Fit the full rate carriage through the slots in the frame and position the ribbon cable round
the guide on the half rate carriage.
13. Slide both carriages fully to the right, and install the cable clamps so the cable are under
the clamps as shown in Figure 4.
Outboard
Figure 4 Cable clamps
14. Hold the carriages fully to the right and tighten the clamps.
15. Move the carriages from one end to the other to ensure the windings are straight and
even.
16. Reinstall the DADH, REP 5.19. Reinstall the CVT glass and document glass, REP 14.6A.
WorkCentre 5687 Family
Inboard
Cable
Cable
August 2007
4-577
Repairs/Adjustments
REP 14.12A