Xerox WorkCentre 5687 Series Service Manual page 1601

REP 14.2B Top Cover (65-87 ppm)
Parts List on PL 14.10.
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the DADH, REP 5.19.
2. Remove the user interface assembly, REP 2.1. It is not necessary to disconnect the PJ.
3. Figure 1, remove the top cover.
4
Lift off the top cover
2
1 Loosen three screws
Remove one screw
Figure 1 Top cover removal
Replacement
1. The replacement procedure is the reverse of the removal procedure.
2. Perform ADJ 14.1B Optics Cleaning as necessary.
WorkCentre 5687 Family
REP 14.3B CVT Glass, CVT Ramp Assembly and
Document Glass (65-87 ppm)
Parts List on PL 14.10.
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Careless handling may separate the plastic CVT ramp assembly from the document glass. If
this happens, install a new document glass, PL 14.10 Item 5 and CVT ramp assembly, PL
14.10 Item 13.
3
Contamination of the optics cavity can cause image quality defects. Do not allow the optics
Remove
cavity to be contaminated.
three
screws
1. Remove the top cover, REP 14.2B.
2. Remove the CVT glass, PL 14.10 Item 4.
3. If necessary, remove the CVT ramp assembly, PL 14.10 Item 13.
NOTE: If only the CVT ramp assembly is to be replaced, do not remove the document
glass.
4. Figure 1, document glass and CVT ramp assembly.
August 2007
4-581
WARNING
WARNING
CAUTION
Repairs/Adjustments
REP 14.2B, REP 14.3B