Xerox WorkCentre 5687 Series Service Manual page 1494

4. Figure 1, remove a staple head.
3
Using a 5.5mm socket
and short extension fully
loosen the screw until the
staple head is released.
Leave the socket and
extension in position on
the screw
Figure 1 Staple head removal
Repairs/Adjustments
REP 11.27-171
2
Loosen 1 screw
using a 5.5mm
socket and
ratchet driver
4
1
Disconnect the
Remove 2 screws
stapler harness
using a 5.5mm
and remove the
socket and
stapler
ratchet driver
August 2007
4-474
Replacement
1. Reverse the removal procedure to replace the BM staple heads.
2. Perform ADJ 11.3-171, Stapler Anvil Alignment.
WorkCentre 5687 Family