Xerox WorkCentre 5687 Series Service Manual page 1434

REP 11.55-170 BM Pre-compile Pulley and Tyres
Parts List on PL 11.67
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the compiler carriage assembly, REP 11.2-170.
2. Remove the drive pulley, PL 11.67 Item 2, refer to REP 11.12-170, figure 2.
3. Figure 1, remove the BM pre-compile pulley.
Repairs/Adjustments
REP 11.55-170
1
Remove E-clip
and bearing
3
Push the pulley shaft to the rear and remove from the front
4. Figure 2, remove the BM pre-compile tyres.
August 2007
4-414
2
Remove E-clip
and bearing
Figure 1 Pulley removal
WorkCentre 5687 Family