Xerox WorkCentre 5687 Series Service Manual page 1465

REP 11.6-171 HVF Ejector Assembly Removal
Parts List on PL 11.140
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove Bin 1, REP 11.4-171.
2. Remove the right side-cover REP 11.5-171.
3. Remove the door and the front cover REP 11.1-171.
4. Remove the front pressing plate finger, REP 11.7-171.
5. Remove 1 screw and remove the front tamper from the drive assembly. Remove 2 screws
then remove the ejector front cover, Figure 1.
NOTE: Rotate the ejector encoder wheel to extend the ejector.
Front Tamper
Ejector Front Cover
UNDERSIDE VIEW
Figure 1 Front Tamper and Ejector Cover
WorkCentre 5687 Family
6. Remove 2 screws holding the pressing plate bracket assembly and remove the assembly.
Remove 2 screws and the ground wire then remove the ejector assembly, Figure 2.
Pressing Plate Bracket
Ejector Encoder Wheel
August 2007
4-445
Ejector Assembly
Figure 2 Ejector Assembly
Repairs/Adjustments
REP 11.6-171