Xerox WorkCentre 5687 Series Service Manual page 1676

4
Tighten the two screws alternately a little at a time, while
holding the free screw with a finger. Ensure that the anvil
does not move as the screws are tightened
6. Open the stapler fully by use of the stapler gear, Figure 3, then remove the alignment tool.
7. Perform the adjustment on the other stapler anvil if necessary.
Repairs/Adjustments
ADJ 11.3-170
Figure 3 Closing the stapler
8. Check the operation of the stapler by making a few stapled sets using 2 sheets of 80gsm
(20 pound) paper. check the quality of the staple clinch.
August 2007
4-656
2
Continue to rotate the
stapler gear so that the
two protrusions on the
tool engage with the
depressions in the
anvil. Move the anvil if
necessary using the
two clamp screws
Anvil
Clamp plate
Spacer
1
Rotate the stapler gear counterclockwise
to begin closing the stapler
3
Continue to rotate the stapler gear
until the anvil is tightly clamped by
the alignment tool and the stapler
will close no further
WorkCentre 5687 Family