Table of Contents
Advertisement
ADJ 11.9-170 Booklet Maker Skew
Parts List on PL 11.83
Purpose
The purpose of the procedure is to adjust the skew of the booklet crease.
Check and complete the following adjustments:
•
ADJ 11.6-170 Booklet compiling position.
•
ADJ 11.8-170 Booklet staple position.
•
ADJ 11.7-170 Booklet crease position.
Check
1.
Run a copy job of 3 stapled 4 sheet booklets.
2.
Observe the position of the crease in relation to the open end of the booklet. The fold
should be central, so that the open end of the booklet pages are equal from the fold. If
necessary perform the adjustment.
Adjustment
1.
Slide out the booklet maker and locate the adjustment screw on the booklet backstop,
Figure 1.
2.
Use a 2.5 mm allen head driver and turn the adjustment screw as follows:
•
Turn the screw clockwise to rotate the crease clockwise relative to the centre line.
•
Turn the screw anti-clockwise to rotate the crease anti-clockwise relative to the cen-
tre line.
•
One half turn of the adjustment screw will change the crease angle approximately 3
to 4 mm over the length of the crease.
3.
Run a copy job of 3 stapled 4 sheet booklets to check that the crease is in the centre of
the book. Repeat the adjustment if necessary.
Repairs/Adjustments
ADJ 11.9-170
Figure 1 Booklet crease adjustment
August 2007
4-666
Correct position of the
crease blade fold
Angle of adjustment
Adjustment screw
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
