Xerox WorkCentre 5687 Series Service Manual page 1617

REP 16.1 Network Controller PWB's
Parts List on PL 16.10
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Ensure that E.S.D. procedures are observed during the removal and installation of the PWB.
Use this repair to remove or install a USB print PWB or a colour scanning enablement PWB. It
also identifies the position of the memory modules.
1. Remove the network controller, PL 16.10, from the rear of the machine.
2. Remove the screws securing the front cage, Figure 1.
WorkCentre 5687 Family
Remove 6 screws
Figure 1 Network controller
3. Remove the front cage, Figure 2.
August 2007
4-597
Repairs/Adjustments
REP 16.1