Table of Contents
Advertisement
2
Slide the front of the lower
crease roll and clutch assem-
bly out of the slot.
Figure 4 Lower Crease roll and clutch assembly
WorkCentre 5687 Family
1
Pull the lower crease roll and
clutch assembly to the front to
release the bearing.
3
Remove the lower crease roll
and clutch assembly.
August 2007
Replacement
Do not remove the crease roll and clutch assembly if they are secure on the shaft.
1.
Install the lower crease roll and clutch assembly and bearings.
2.
Check if the lower crease roll gear and clutch assembly are secure on the shaft. If the
lower crease roll gear and clutch assembly wobble, perform the following:
a.
Figure 5, remove the clutch.
Figure 5 Clutch removal
b.
Figure 6, carefully identify the lower crease roll gear and clutch assembly compo-
nents. Reassemble the components on the lower crease roll shaft in sequence from
1 to 12. Ensure the following points are followed:
•
Components are orientated correctly as shown in Figure 6.
•
The shallow grooves in the bore of the gear face towards the rear and mate
with the teeth of the clutch plate installed on the shaft.
•
The deep grooves in the bore of the gear face towards the front and mate with
the teeth of the clutch plates subsequently installed on the shaft.
•
The spring retainer is installed over the end the shaft.
4-509
CAUTION
1
Remove the screw and
the retainer.
2
Remove the 9 nine
clutch plates and the
lower crease roll gear.
Repairs/Adjustments
REP 11.52-171
Hide quick links:
Advertisement
Chapters
Table of Contents
