Xerox WorkCentre 5687 Series Service Manual page 1603

Replacement
1. Install the sensor on to the sensor plate, ensuring the lugs locate correctly in the slot.
2. Re-connect the sensor.
3. Install the sensor plate. Ensure that the three locating lugs are correctly located in the
slots of the mounting plate.
4. The replacement of the removed components in the reverse of the removal procedure.
WorkCentre 5687 Family
REP 14.5B Scan Carriage Assembly (65-87 ppm)
Parts List on PL 14.15.
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the CVT glass and document glass, REP 14.3B.
2. Disconnect the exposure lamp ribbon cable, REP 14.11B.
When disconnecting the scan carriage ribbon cable, do not bend the connector pins.
August 2007
4-583
WARNING
WARNING
CAUTION
Repairs/Adjustments
REP 14.4B, REP 14.5B