Table of Contents
Advertisement
3.
Return the feed roll shaft to the original position and install the E-clips, Figure 1.
4.
Install the bypass tray drive gear and feed head, REP 8.20.
Tray 1 and 2 Support Slides
1.
Remove tray 1 and 2, REP 7.1.
2.
Figure 2, use molub grease 777, PL 26.10 Item 20, to lubricate the support slides.
Apply grease to the upper
surface of the left slides
Figure 2 Tray 1 and 2 support slides
3.
Lubricate the stack height mechanism actuator located at the rear left side of the tray and
the paper width guides.
4.
Re-install tray 1 and 2, REP 7.1.
Tray 3 Takeaway Roll Assembly
Parts list on: PL 8.35 Item 2.
1.
Remove the tray 3 takeaway roll assembly, REP 8.29.
2.
Use molub grease 777, PL 26.10 Item 20, to lubricate the two areas of the shaft normally
located within the bearings.
3.
Re-install the tray 3 takeaway roll assembly. REP 8.29.
Repairs/Adjustments
ADJ 4.1
Tray 3 Transport Roll Assembly
Parts list on: PL 8.35 Item 11.
1.
Remove the tray 3 transport assembly, REP 8.13.
2.
Figure 3, use molub grease 777, PL 26.10 Item 20, to lubricate the tray 3 transport roll
assembly.
Apply grease to the upper
surface of the right slides
3.
Re-install the tray 3 transport roll assembly.
4.
Re-install the tray 3 transport assembly, REP 8.13.
August 2007
4-604
5
Apply grease to the 2 areas of
4
the shaft that are normally inside
the bearings
Remove E-clip, slide
shaft to the rear
3
2
Slide pulley and
Remove E-clip and
belt from the shaft.
inner coupling
Figure 3 Transport roll removal
1
Spring open the legs and
remove the outer coupling
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
