Xerox WorkCentre 5687 Series Service Manual page 1512

REP 11.38-171 HVF Stacker Driving Belts
Parts List on PL 11.135
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
NOTE: The removal and replacement procedure for the front and rear stacker driving belts is
the same. Support the Bin 1 lift bar if removing the front and rear belts at the same time
1. Remove the front or rear cover to access the front or rear driving belt REP 11.1-171.
2. Remove the stacker bin 1 tray REP 11.4-171.
3. Remove the belt clamp, Figure 1.
4. Remove the circlip and lower pulley to relieve the driving belt tension, Figure 1.
5. Remove the driving belt from the upper pulley and idler, Figure 1.
Repairs/Adjustments
REP 11.38-171
Figure 1 Stacker Driving Belts
Replacement
NOTE: Check that the bin 1 lift bar is level before fitting the belt clamp.
Reverse the removal procedures to reinstall the front and rear stacker driving belts.
August 2007
4-492
Remove the upper pulley
if required.
Belt Clamp
Lower Pulley
WorkCentre 5687 Family