Xerox WorkCentre 5687 Series Service Manual page 1466

7. Withdraw and support the ejector assembly. Disconnect the two PJs; the Bin 1 rear wall
sensor must be disconnected at the PJ or un-clipped from the bracket Figure 3.
EJECTOR UNDERSIDE VIEW
Figure 3 Ejector Electrical Connections
Replacement
NOTE: Set the front and rear support fingers so that their ends are aligned when extended.
See REP 11.8-171.
Reverse the removal procedures to reinstall the ejector assembly.
When reinstalling the front tamper and the ejector front cover make sure that the correct
screws are used and that the screws are not overtightened GP 6.
Repairs/Adjustments
REP 11.6-171
When refitting the pressing plate, the shaft of the front support finger drive gear must fit in ejec-
tor assembly, see Figure 4. Replace the front pressing plate finger.
Bin 1 Rear Wall
Sensor PJ
Ejector PJs
August 2007
4-446
Front Pressing Plate Finger
Move the cover to the front
to locate the shaft end.
End of the
gear shaft
Figure 4 Reinstalling the Pressing Plate
WorkCentre 5687 Family