Xerox WorkCentre 5687 Series Service Manual page 1060

3
Slide the assembly off the
2
location dowels
Remove 7 silver screws
marked A
Figure 6 Main drive module
18. Slide the assembly off of the location dowels.
Repairs/Adjustments
REP 4.1A
Replacement
Replacement is the reverse of the removal procedure.
Do not trap the harnesses when the main drives module is located onto the dowels.
Take care when reconnecting PJ1 on the IOT PWB, the pins can easily be damaged.
Perform the following:
1. It is important that the short paper path assembly is held in the UP position before install-
ing the main drives module, Figure 7.
1
Disconnect PJ147,
PJ148 and PJ149
Support the short paper path
2. If a new main drives module is installed, check that the drive speed is correct. The 32-38
ppm modules have black drive gears, Figure 8. The 45-55 ppm modules have white drive
gears, Figure 9.
3. Lubricate the developer module support pin on the main drive module drives plate with
Plastislip grease, (32-38 ppm) Figure 8, (45-55 ppm) Figure 9.
August 2007
4-40
CAUTION
Figure 7 Short paper path assembly
WorkCentre 5687 Family