Xerox WorkCentre 5687 Series Service Manual page 1453

Replacement
CAUTION
Do not damage the harnesses when the BM module is installed. Ensure that the rails are cor-
rectly aligned with the slides.
1. Put the BM module on the paper stack in front of the HCSS BM.
2. Route the bin 2 harness and the ground harness to the rear of the HCSS BM.
3. If a new BM is to be installed, perform the following:
a. Unlatch the slides from the new BM module. Refer to Figure 5.
b. Install the new BM module onto the existing rails in the HCSS BM.
4. Figure 7, prepare to install the BM module.
WorkCentre 5687 Family
1
Hold the catch in the forward position.
Figure 7 Position of the catch
5. Reverse the removal procedure to replace the BM module.
Ensure that the BM harness and bin 2 harness are correctly positioned in the harness retainers
to prevent harness damage when the BM is moved to the extremities of its travel.
6. Perform the 11F-170 Booklet Quality RAP.
August 2007
4-433
2
Carefully push the BM module into the
HCSS BM until the catch is held under
the guide. Do not push the BM further
into HCSS BM.
Guide
CAUTION
Repairs/Adjustments
REP 11.61-170