Xerox WorkCentre 5687 Series Service Manual page 1520

REP 11.45-171 HVF Buffer Upper Roll
Parts List on PL 11.155
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Figure 1. Remove the circlip and the bush.
Fixed guide
Figure 1 Circlip and bush removal
Repairs/Adjustments
REP 11.45-171
6.
1
Remove the circlip
and the bush
2
Replacement
Remove the screw
The replacement procedure is the reverse of the removal procedure.
3
Loosen screw
August 2007
4-500
Figure 2. Remove the buffer upper roll.
1
Remove the circlip
7
Pull the upper part of the fixed
guide to the left and remove the
buffer upper roll
REAR VIEW
Figure 2 Buffer upper roll removal.
2
Slide the pulley and the
bush along the shaft
3
Slip the belt off the pul-
ley
4
Remove the pulley and
the bush
5
Remove the screw
6
Loosen the screw
WorkCentre 5687 Family